QuasiPITech Contact
Rocket family A–G · class A

Class A – Estes A8-3

Design v19 · not printed or flown yet · 2027 season

3D-printed model rocket from the QuasiPI rocket family, airframe A/B/C. The same airframe also flies B6 and C6 motors – see classes B and C.

ABS / ASAFDMBarrowmanclass A
Class A
length
354 mmbody Ø21, fin span 93 mm
mass
≈73 gwith motor (ABS/ASA)
apogee
≈50 mestimate
stability
2.1calibres (estimate)
Data

Specification

Motor classA
Motors
  • Estes A8-3 (18 × 70 mm, 2.5 N·s) – delay 3
Dimensions354 mm × Ø21, fin span 93 mm
Lift-off mass≈73 g (motor limit 85 g (A8-3))
Stability margin2.1 calibres
Estimated apogee≈50 m
Speed leaving the guide≈10 m/s
Launcher3 mm rod, min. 0.9 m – two launch lugs
RecoveryStreamer 2.5 × 60 cm, Kevlar 0.8 m
MaterialABS or ASA (ASA-CF possible for the motor section). Never PLA next to the motor – it softens at ≈60 °C. Printed in an enclosed chamber (60 °C).
Heat protectionMotor wrapped in aluminium or Kapton tape, fire-proof wadding above the motor.
Construction

How it is built

  • Harmonica wall (from the original R02): 1.0 mm skin with internal longitudinal ribs to 2.0 mm, plus 3 internal ring frames per tube. ≈18 % lighter than a plain 2 mm wall, protects the thin skin against dents and cracking layers. Outer diameter unchanged.
  • Fins printed with the body (no glue, cannot fall off), 2.4–2.8 mm thick, with R4 concave fillets that fade smoothly into a fully rounded leading edge.
  • Motor locked both ways: forward stop ring + screw-in retainer / threaded sleeve and nut – never just a friction fit.
  • Two guide points on the launcher (two lugs or two rail buttons) so the rocket cannot rock on the rod.
  • Estimated drag reduction from the rounded leading edges: ≈20–35 % of total Cd (semi-empirical estimate).
Interactive 3D

The 3D model: assembled, exploded, cut away

drag to rotate · scroll or pinch to zoom · built from the print files (simplified mesh)
Flight simulator

How high will it fly? Pick a motor

1-D simulation: average catalogue thrust (approximate), Cd from a Barrowman estimate, mass from the 3D models. An estimate, not a measurement: the rocket has not flown yet.

Renders

Rendered from the actual print files

Class A render
Class A render
Class A render
Class A detail
Class A detail
Plan – 2027 season
  • The family is being prepared for the next season (2027).
  • Every class will be printed, weighed, balanced and test-flown.
  • The goal is to work towards certification for each level of the family.
Honest status
  • Not printed or flown yet – all figures are estimates from the 3D models (Barrowman method, 1-D flight model, approximate catalogue motor data).
  • Before the first flight the rocket must be weighed and its centre of gravity checked: margin = (CP − CG) / diameter ≥ 1.5.
  • Fly only under local rules and with the required permissions.
Label

QR code on the rocket

Every rocket carries a QR code that opens this page.

QR code for class A