QuasiPITech Contact
Rocket family A–G · class E

Class E – Estes E12-6

Design v19 · not printed or flown yet · 2027 season

3D-printed model rocket from the QuasiPI rocket family, airframe D/E. 8 g of nose ballast is part of the design – without it the stability margin drops below 1.5 calibres.

ABS / ASAFDMBarrowmanclass E
Class E
length
561 mmbody Ø36, fin span 140 mm
mass
≈244 g (with 8 g nose ballast)with motor (ABS/ASA)
apogee
≈380 mestimate
stability
1.6calibres (estimate)
Data

Specification

Motor classE
Motors
  • Estes E12-6 (24 × 97 mm, ≈28–30 N·s)
Dimensions561 mm × Ø36, fin span 140 mm
Lift-off mass≈244 g (with 8 g nose ballast) (motor limit 397 g (E12))
Stability margin1.6 calibres
Estimated apogee≈380 m
Speed leaving the guide≈10 m/s
Launcher5 mm rod, 1.5 m – two launch lugs
Recovery35 cm parachute, Kevlar 1.7 m
MaterialABS or ASA (ASA-CF possible for the motor section). Never PLA next to the motor – it softens at ≈60 °C. Printed in an enclosed chamber (60 °C).
Heat protectionMotor wrapped in aluminium or Kapton tape, fire-proof wadding above the motor.
Construction

How it is built

  • Harmonica wall (from the original R02): 1.0 mm skin with internal longitudinal ribs to 2.0 mm, plus 3 internal ring frames per tube. ≈18 % lighter than a plain 2 mm wall, protects the thin skin against dents and cracking layers. Outer diameter unchanged.
  • Fins printed with the body (no glue, cannot fall off), 2.4–2.8 mm thick, with R4 concave fillets that fade smoothly into a fully rounded leading edge.
  • Motor locked both ways: forward stop ring + screw-in retainer / threaded sleeve and nut – never just a friction fit.
  • Two guide points on the launcher (two lugs or two rail buttons) so the rocket cannot rock on the rod.
  • Estimated drag reduction from the rounded leading edges: ≈20–35 % of total Cd (semi-empirical estimate).
Interactive 3D

The 3D model: assembled, exploded, cut away

drag to rotate · scroll or pinch to zoom · built from the print files (simplified mesh)
Flight simulator

How high will it fly? Pick a motor

1-D simulation: average catalogue thrust (approximate), Cd from a Barrowman estimate, mass from the 3D models. An estimate, not a measurement: the rocket has not flown yet.

Renders

Rendered from the actual print files

Class E render
Class E render
Class E render
Class E detail
Class E detail
Plan – 2027 season
  • The family is being prepared for the next season (2027).
  • Every class will be printed, weighed, balanced and test-flown.
  • The goal is to work towards certification for each level of the family.
Honest status
  • Not printed or flown yet – all figures are estimates from the 3D models (Barrowman method, 1-D flight model, approximate catalogue motor data).
  • Before the first flight the rocket must be weighed and its centre of gravity checked: margin = (CP − CG) / diameter ≥ 1.5.
  • Fly only under local rules and with the required permissions.
Label

QR code on the rocket

Every rocket carries a QR code that opens this page.

QR code for class E